Honeywell Humidifier HCM-1000 Series Manual

The Honeywell HCM-1000 Series is a cool mist humidifier designed to add moisture to dry indoor air, providing relief from dry skin, nasal congestion, and static electricity. It features a large-capacity tank, adjustable humidity control, a quiet operation mode, an easy-to-clean design, an automatic shut-off function when empty, and a filter to help reduce white dust. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Water Tank, Base Unit with Motor and Fan, Humidistat Control Knob, Mist Outlet, Filter, Power Cord, and Carry Handle.

Installation & Setup

Unpack and inspect all contents. Place on a stable, level surface away from walls and electronics.

1. Remove all packaging materials from the humidifier and tank.
2. Install the filter: Remove from packaging, soak in cool water for 15 minutes, then insert into the base unit.
3. Fill the tank: Carry tank to sink, remove cap, fill with cool tap water, replace cap securely.
4. Place tank on base: Align tank with base and set down gently until seated.
5. Plug into a standard 120V AC electrical outlet.

WARNING! Place humidifier on a waterproof mat or towel. Do not place on carpet or uneven surfaces. Keep cord away from heated surfaces.

First-Time Use

After installation, follow these steps to begin operation.

1. Ensure the humidifier is unplugged and the tank is filled.
2. Plug the power cord into the outlet. The power indicator light will illuminate.
3. Turn the humidity control knob to the desired setting (Low to High).
4. Adjust the mist outlet to direct the cool mist away from walls and furniture.
5. The humidifier will begin producing mist. Allow 15-30 minutes to notice increased room humidity.

CAUTION! Use only cool, clean tap water. Do not use hot water, distilled water with additives, or essential oils unless specified.

Specifications

• Model Series: HCM-1000 (e.g., HCM-1001, HCM-1002).
• Tank Capacity: 1 Gallon (3.8 Liters).
• Room Coverage: Up to 250 square feet.
• Run Time: Up to 24 hours on low setting.
• Output: Up to 1 gallon per day.
• Power: 120V AC, 60Hz.
• Power Consumption: 30 Watts (max).
• Noise Level: < 35 dB on low setting.
• Dimensions (approx.): 12" H x 10" W x 8" D.
• Weight (empty): 5 lbs.
• Filter Type: Demineralization Cartridge (replace every 1-2 months).

Controls and Operation

Primary control is the Humidity Control Knob on the front or side of the unit.

Control Knob: Rotate clockwise from OFF to LOW, MEDIUM, and HIGH mist output. The further the turn, the higher the humidity output.

Indicator Lights: Power Light (Green) indicates unit is on. Some models may have a "Check Filter" or "Empty" indicator.

Automatic Operation: The humidistat works with the knob setting to maintain a comfortable humidity level. The fan speed adjusts automatically. The unit will shut off completely when the tank is empty (Auto Shut-Off).

Manual Override: For constant output, set knob to HIGH. For quiet nighttime operation, set to LOW.

Maintenance & Cleaning

Regular cleaning prevents mold and mineral buildup. Unplug the unit before any maintenance.

1. Daily: Refill tank with fresh, cool water.
2. Weekly: Empty any remaining water from the base. Wipe the tank interior and base with a soft, damp cloth.
3. Bi-Weekly/Deep Clean: Mix 1 teaspoon of white vinegar with 1 gallon of water. Use this solution to rinse the tank and base. Scrub gently with a soft brush. Rinse thoroughly 2-3 times with clean water to remove vinegar smell.
4. Dry all parts completely before reassembly or storage.

WARNING! Never use harsh chemicals, abrasives, or detergents. Do not immerse the motor base in water.

Replacing the Filter

The demineralization filter should be replaced every 1-2 months, or more often in hard water areas.

1. Unplug the humidifier and remove the water tank.
2. Locate the filter compartment in the base.
3. Remove the old filter and discard it.
4. Take the new filter from its package and soak it in cool water for 15 minutes.
5. Insert the soaked filter into the compartment, ensuring it is seated properly.
6. Reassemble the unit and run for a few minutes to prime the new filter.

Note: Using the humidifier without a filter may result in white dust on surfaces. Use only genuine Honeywell HCM-1000 series replacement filters.

Storage Instructions

When not in use for extended periods (e.g., summer months), prepare the humidifier for storage.

1. Unplug the unit.
2. Empty and thoroughly clean the tank and base as per deep clean instructions.
3. Remove and discard the old filter. Do not store a used, wet filter inside the unit.
4. Allow all parts to air dry completely for 24-48 hours.
5. Reassemble the dry unit and store in its original box in a cool, dry place.

CAUTION! Never store with water in the tank or base, as this can lead to mold and damage.

Safety Information

Important Safety Instructions: Read all instructions before use.

• Use only as described in this manual.
• Plug into a 120V outlet only. Do not use an extension cord.
• Do not operate if cord or plug is damaged, or if unit malfunctions.
• To reduce risk of fire, do not block air intakes or outlets.
• Do not place under shelves or in enclosed spaces.
• Keep out of reach of children and pets.
• Do not add medications or essential oils to the water tank unless the unit is specifically designed for it.
• The humidifier must be placed on a firm, flat, level surface.

SAVE THESE INSTRUCTIONS.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This product is listed by Underwriters Laboratories (UL). Copyright and Trademarks: Honeywell and the Honeywell logo are registered trademarks of Honeywell International Inc. For support, visit www.honeywellpluggedin.com or contact Honeywell Consumer Products at 1-800-332-1110.

Troubleshooting

For Service: Do not attempt to repair the unit yourself. Contact Honeywell Consumer Products at 1-800-332-1110 or visit the support website.