Honeywell Humidifier HCM-6009 - QuietCare Lon Console Manual

The Honeywell HCM-6009 QuietCare Console Humidifier is a high-capacity, whole-room humidifier designed for spaces up to 2300 sq ft. It features a 1.5-gallon output per day, quiet operation, a refill indicator, a wicking filter, an easy-to-clean tank, and three speed settings. It helps relieve dryness in the air due to heating systems. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Console unit with water tank, wicking filter, control panel, humidistat, refill indicator, and power cord.

Installation & Setup

Unpack and inspect all contents. Place unit on a firm, level, waterproof surface away from electronics and furniture.

1. Remove tank: Lift tank from base and remove cap.
2. Fill tank: Use cool, clean tap water. Do not use hot water or additives.
3. Install filter: Remove filter from packaging, soak in cool water for 15 minutes, then place in base.
4. Replace tank: Place filled tank back onto base, ensuring it is seated properly.
5. Plug in: Connect power cord to a standard 120V AC outlet.

WARNING! Always place humidifier on a waterproof mat or towel. Do not place on carpet. Ensure unit is upright and stable.

First-Time Use

After installation, follow these steps to begin operation.

1. Power on: Press the POWER button. The power indicator will light.
2. Set humidity: Turn the HUMIDISTAT dial to desired level (recommended 35-45% for comfort).
3. Select fan speed: Choose LOW, MEDIUM, or HIGH using the SPEED button.
4. Monitor operation: The unit will run until desired humidity is reached or tank is empty.
5. Refill when needed: Refill indicator light will illuminate when tank is low.

CAUTION! Use only clean, cool water. Never operate without the filter installed.

Specifications

• Model: HCM-6009 QuietCare Console Humidifier
• Coverage: Up to 2300 square feet
• Output: 1.5 gallons per day (maximum)
• Water Tank Capacity: 1.5 gallons
• Fan Speeds: 3 (Low, Medium, High)
• Controls: Power button, Speed button, Humidistat dial
• Filter Type: Wicking filter (replacement part #HWF-100)
• Power Source: 120V AC, 60Hz
• Noise Level: Ultra-quiet operation
• Dimensions: Approximately 17.5" H x 13.5" W x 11" D
• Weight: 10.5 lbs (empty)

Controls and Operation

Control Panel: POWER button, SPEED button, HUMIDISTAT dial, REFILL indicator light, POWER indicator light.

Operation: Press POWER to turn on/off. Press SPEED to cycle through fan speeds. Adjust HUMIDISTAT to set target humidity level. The unit will run intermittently to maintain set level. REFILL light illuminates when water level is low.

Optimal Settings: For general use, set humidistat to 40-45%. Use LOW speed for quiet nighttime operation, MEDIUM for daytime, HIGH for rapid humidification in dry conditions.

Maintenance & Cleaning

Regular cleaning prevents mold and mineral buildup. Unplug unit before any maintenance.

1. Daily: Check water level and refill as needed with clean, cool water.
2. Weekly: Empty any remaining water, clean tank with mild detergent and soft brush, rinse thoroughly.
3. Bi-Weekly: Wipe base interior with a damp cloth. Check filter for mineral deposits.
4. Monthly: Deep clean tank and base with a solution of 1 cup white vinegar and 1 gallon water. Rinse completely.

Tip: Always allow all parts to air dry completely before reassembling and using.

Filter Replacement

The wicking filter should be replaced every 1-2 months, depending on water hardness and usage.

1. Unplug unit and remove water tank.
2. Lift out the old filter from the base.
3. Soak new filter (HWF-100) in cool water for 15 minutes.
4. Place soaked filter into the base, ensuring it sits flat.
5. Replace tank and plug in unit.

WARNING! Never operate the humidifier without a filter. A clogged or old filter reduces efficiency and can cause malfunctions.

Safety Features

Automatic Shut-Off: Turns off when water tank is empty or improperly seated. Tip-Over Protection: Internal switch cuts power if unit is knocked over. Overheat Protection: Thermal fuse prevents motor overheating.

Care & Storage

When not in use for extended periods, prepare unit for storage.

1. Unplug and empty all water from tank and base.
2. Clean thoroughly as per monthly cleaning instructions.
3. Allow all parts to dry completely.
4. Remove and discard old filter.
5. Reassemble unit without filter and store in original box in a cool, dry place.

CAUTION! Never store with water inside. This can lead to mold and damage.

Regulatory Information

This humidifier complies with FCC Part 15 Class B digital device limits. It is listed by UL (Underwriters Laboratories) for safety. Manufactured for Honeywell International Inc. For support, visit www.honeywellhumidifiers.com or contact customer service at 1-800-332-1110.

Troubleshooting

Reset: Unplug unit for 5 minutes, then plug back in.

Service: 1-800-332-1110; www.honeywellhumidifiers.com