Honeywell Humidifier HE220B Manual

The Honeywell Humidifier HE220B is a cool mist humidifier designed to add moisture to dry air, helping to relieve dryness in the air that can cause irritation to many parts of the body. It features a 2-gallon tank capacity, adjustable humidity control, quiet operation, a wicking filter to trap minerals and impurities, an easy-to-fill tank, and an automatic shut-off when the water level is low. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Water Tank, Base Unit with Motor, Wick Filter, Humidity Control Dial, Tank Cap, Mist Outlet.

Installation & Setup

Unpack and inspect all contents. Place on a flat, stable, level surface.

1. Remove all packaging materials from the humidifier and tank.
2. Install the wick filter: Remove from package, soak in cool water for 15-20 minutes, then insert into base unit.
3. Fill the tank: Remove tank from base, unscrew cap, fill with cool tap water to the fill line, replace cap securely.
4. Place tank on base: Align tank with base and set firmly in place.
5. Plug into a standard 120V AC electrical outlet.

WARNING! Place humidifier on a water-resistant surface. Keep away from heat sources and direct sunlight. Do not block mist outlet.

First-Time Use

After installation, follow these steps for initial operation.

1. Ensure the wick filter is properly soaked and installed.
2. Fill the water tank completely and place on base.
3. Plug in the power cord. The indicator light will illuminate.
4. Turn the Humidity Control Dial to the desired setting (Low to High).
5. Adjust the Mist Outlet to direct moisture away from walls and furniture.
6. Allow up to 15 minutes for the wick to fully saturate and mist to begin.

CAUTION! Use only cool, clean tap water. Do not use hot water, distilled water, or add any chemicals, oils, or fragrances.

Specifications

• Model: HE220B
• Tank Capacity: 2 Gallons (7.6 Liters)
• Run Time: Up to 24 hours (Low setting)
• Room Coverage: Up to 400 square feet
• Mist Output: Adjustable, up to 1.2 gallons per day
• Technology: Cool Mist Evaporative
• Filter Type: Replaceable Wick Filter (Model HWF220)
• Power Source: 120V AC, 60Hz
• Power Consumption: 25 Watts (max)
• Dimensions (LxWxH): Approx. 12.5" x 10.5" x 17.5"
• Weight (Empty): 5.5 lbs

Controls and Operation

Primary control is the Humidity Control Dial on the front of the base unit.

Operation: Turn dial clockwise to increase mist output (HIGH) and counter-clockwise to decrease (LOW). The unit will run continuously until the tank is empty or turned off.

Automatic Shut-Off: The humidifier will automatically turn off when the water tank is empty or if the tank is removed from the base. The power indicator light will remain on as long as the unit is plugged in.

Refilling: When the tank is empty, remove it, refill with cool water, and replace. The unit will resume operation if the dial is in the ON position.

Maintenance & Cleaning

Regular cleaning prevents mold and mineral buildup.

1. Unplug the unit before any cleaning.
2. Daily: Empty any remaining water from the tank and base. Rinse with clean water.
3. Weekly Cleaning: Clean tank and base with a mixture of 1 teaspoon of white vinegar and 1 gallon of water. Use a soft brush to scrub interior surfaces. Rinse thoroughly.
4. Drying: Allow all parts to air dry completely before reassembly or storage.
5. Exterior: Wipe with a soft, damp cloth. Do not use abrasive cleaners.

WARNING! Never immerse the base unit, motor, or electrical parts in water. Do not use bleach, detergents, or chemical cleaners.

Replacing the Filter

The wick filter should be replaced every 1-2 months, or more often in hard water areas or with continuous use.

1. Unplug the humidifier and remove the water tank.
2. Remove the old wick filter from the base.
3. Soak the new filter (Model HWF220) in cool water for 15-20 minutes.
4. Insert the soaked filter into the base, ensuring it sits flat and contacts the water.
5. Reassemble the tank and base, then plug in the unit.

Tip: A dirty or clogged filter will reduce mist output and efficiency. Always use genuine Honeywell replacement filters.

Safety Features

Automatic Shut-Off: Activates when the water tank is empty or improperly seated, preventing the motor from running dry.

Tip-Over Protection: The unit is designed to stop mist output if tipped over.

Cool Mist Operation: No hot water or steam, making it safe for use around children and pets.

Care & Storage

When not in use for an extended period, prepare the humidifier for storage.

1. Unplug the unit.
2. Empty and thoroughly clean the tank and base as described in the cleaning section.
3. Remove and discard the used wick filter.
4. Allow all parts to dry completely.
5. Reassemble the unit and store in its original box in a cool, dry place.
6. Install a new filter when preparing for next use.

CAUTION! Never store the unit with water in the tank or base, as this can promote mold and bacterial growth.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This product is intended for household use only. Copyright and trademarks are property of Honeywell International Inc. For customer support, product information, or to purchase replacement filters, visit www.honeywellhumidifiers.com or contact 1-800-332-1110.

Troubleshooting

Service: For issues not resolved above, contact Honeywell Customer Service at 1-800-332-1110 or visit www.honeywellhumidifiers.com. Do not attempt to repair the unit yourself.