Honeywell Humidifier HE225A1006 Manual

The Honeywell Humidifier HE225A1006 is a cool mist humidifier designed for medium to large rooms up to 500 square feet. It features a 1-gallon tank capacity, adjustable humidity control, a wicking filter system, a refill indicator light, a quiet operation mode, an easy-to-clean design, and an auto-shutoff function when empty. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Water Tank, Base Unit with Motor, Wicking Filter, Humidity Control Dial, Refill Indicator Light, Mist Outlet, and Power Cord.

Installation & Setup

Unpack and inspect all components. Place on a stable, level surface away from walls and electronics.

1. Remove the water tank from the base unit.
2. Install the wicking filter: Remove from packaging and insert into the filter compartment in the base.
3. Fill the tank with cool, clean tap water. Do not use hot water or additives.
4. Place the tank back onto the base, ensuring it is seated properly.
5. Plug the power cord into a standard 120V AC outlet.

WARNING! Always place the humidifier on a water-resistant surface. Do not operate on carpet. Ensure the unit is unplugged when filling.

First-Time Use

After installation, follow these steps for initial operation.

1. Turn the humidity control dial to the desired setting (Low, Medium, High).
2. The unit will begin producing mist. Adjust the mist outlet direction as needed.
3. Allow the wicking filter to fully saturate with water (approximately 15-20 minutes) for optimal performance.
4. The refill indicator light will illuminate when the tank is empty.

CAUTION! Use only clean, cool water. Do not add essential oils, fragrances, or cleaning chemicals to the water tank, as this may damage the unit or void the warranty.

Specifications

• Model: HE225A1006
• Coverage Area: Up to 500 square feet
• Tank Capacity: 1 gallon (3.8 liters)
• Run Time: Up to 24 hours (low setting)
• Humidity Output: Adjustable, up to 1.2 gallons per day
• Filter Type: Replaceable wicking filter (Part # HE225A1006F)
• Power: 120V AC, 60Hz, 25W
• Noise Level: < 35 dB on low setting
• Dimensions (HxWxD): 15.5" x 10.5" x 10.25"
• Weight (Empty): 5.5 lbs

Controls and Operation

Primary controls are located on the front of the base unit.

Humidity Control Dial: Rotate to select mist output level (Low, Medium, High). Turning to "OFF" powers down the unit.

Refill Indicator Light: A red LED that lights up when the water tank is empty, reminding you to refill.

Mist Outlet: Can be rotated 360 degrees to direct mist flow away from walls, furniture, or electronics.

Operation Tips: For best results, maintain indoor humidity between 40% and 60%. Use a hygrometer to monitor room humidity. Clean the unit regularly as described in the Maintenance section.

Maintenance & Cleaning

Regular cleaning prevents mold, mineral buildup, and ensures efficient operation.

1. Daily: Empty any remaining water from the tank and base. Rinse with clean water.
2. Weekly Cleaning:
   • Unplug the unit.
   • Fill the tank with a mixture of 1 cup white vinegar and 1 gallon water. Let sit for 20 minutes.
   • Scrub the interior with a soft brush. Rinse thoroughly with clean water.
   • Wipe the exterior with a damp cloth.
3. Before Storage: Perform a thorough cleaning and ensure all parts are completely dry.

WARNING! Never immerse the base unit in water. Do not use abrasive cleaners or chemicals.

Filter Replacement

The wicking filter should be replaced every 1-2 months, or more frequently in hard water areas.

1. Unplug the humidifier and remove the water tank.
2. Locate the filter compartment on the base.
3. Remove the old filter and dispose of it.
4. Insert the new filter (Honeywell Part # HE225A1006F). Ensure it is seated flat.
5. Reassemble the unit and run it for 15 minutes to saturate the new filter.

Note: Using a non-genuine or worn-out filter can reduce performance, increase noise, and cause mineral dust (white dust) to be emitted.

Safety Features

Auto Shut-Off: The unit will automatically power off when the water tank is empty, protecting the motor.

Tip-Over Protection: If the unit is knocked over, it will shut off automatically.

Refill Indicator: The red light alerts you to add water, preventing dry running.

Care & Storage

When not in use for extended periods, prepare the humidifier for storage.

1. Unplug the unit.
2. Empty and thoroughly clean the tank and base as per weekly instructions.
3. Remove and discard the old filter. Do not store the unit with a used, wet filter inside.
4. Ensure all parts are completely dry.
5. Reassemble and store in the original box or a clean, dry place.

CAUTION! Storing the unit while wet can lead to mold and mildew growth, causing odors and potential health risks.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Copyright © Honeywell International Inc. Honeywell and the Honeywell logo are registered trademarks. For customer support, replacement filters, or warranty service, visit www.honeywellhumidifiers.com or contact 1-800-332-1110.

Troubleshooting

Reset: Unplug the unit for 60 seconds to reset the electronic controls.

Service: For warranty service or technical support, call 1-800-332-1110 or visit www.honeywellhumidifiers.com.