Honeywell Humidifier HE265B1005 Manual

The Honeywell HE265B1005 is a high-performance evaporative humidifier designed for large rooms up to 2300 sq. ft. It features a 3.6-gallon tank capacity, dual-speed settings, a wicking filter system, a humidistat for automatic humidity control, a refill indicator light, easy-carry handles, and a quiet operation design. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Large-capacity water tank, Dual-speed fan control, Wicking filter, Built-in humidistat, Refill indicator light, Easy-carry handles, Power cord with storage.

Installation & Setup

Unpack and inspect all components. Place on a level, stable surface away from direct heat sources.

1. Remove the water tank and base unit from packaging.
2. Install the wicking filter: Remove filter from plastic bag and insert into the filter frame in the base unit.
3. Fill the tank with clean, cool water. Do not use hot water or additives.
4. Place the tank back onto the base unit, ensuring it is seated properly.
5. Plug the power cord into a standard 120V AC outlet.

WARNING! Always place the humidifier on a waterproof mat or towel to protect flooring from potential moisture. Ensure the unit is on a flat, stable surface to prevent tipping.

First-Time Use

Power on the humidifier and set your desired humidity level.

1. Turn the Humidistat dial to your desired setting (recommended 35-50% relative humidity).
2. Select fan speed: HIGH for rapid humidification, LOW for quiet, maintenance operation.
3. The unit will begin evaporating moisture. The refill light will illuminate when the tank is empty.
4. Monitor humidity levels and adjust the humidistat as needed for comfort.

CAUTION! Use only clean, cool tap water. Do not operate without the filter installed. Never move the unit while it is operating or filled with water.

Specifications

• Model: HE265B1005
• Type: Evaporative Console Humidifier
• Coverage Area: Up to 2300 sq. ft.
• Tank Capacity: 3.6 gallons (13.6 L)
• Output: Up to 2.3 gallons per day (depending on settings)
• Fan Speeds: 2 (High/Low)
• Controls: Manual dial humidistat, Fan speed switch
• Filter Type: Replaceable wicking filter (Model HWF-360)
• Power Requirements: 120V AC, 60Hz
• Dimensions (approx.): 20.5" L x 15.5" W x 19.5" H
• Weight (empty): 15.4 lbs (7 kg)

Controls and Operation

Control Panel located on top front of unit.

Main Controls: POWER/HUMIDISTAT Dial (Off, Low Humidity, High Humidity), FAN SPEED Switch (High/Low).

Indicator Light: REFILL light (red) illuminates when water tank is empty and needs refilling.

Operation: Set humidistat to desired level. The unit will cycle on and off automatically to maintain that humidity. Use HIGH fan speed for faster humidification or in very dry conditions. Use LOW fan speed for quieter operation and maintenance of humidity.

Maintenance & Filter Care

Regular maintenance ensures optimal performance and air quality.

1. Filter Replacement: Replace the wicking filter every 1-2 months during the season, or as needed (signs: reduced output, white dust, odor). Use Honeywell HWF-360 filter.
2. Daily: Refill the water tank as needed when the REFILL light comes on.
3. Weekly: Inspect the filter for scaling or debris. Rinse if lightly soiled.
4. End of Season: Perform a thorough cleaning (see Cleaning section) and dry all parts completely before storage.

Tip: Using demineralization cartridges or distilled water can extend filter life and reduce white dust.

Cleaning Instructions

Unplug the unit and empty all water before cleaning.

1. Remove the water tank and empty any remaining water.
2. Remove the wicking filter from the base.
3. Clean the tank with a mixture of mild dish soap and warm water. Rinse thoroughly. Do not submerge the tank base (where handles are attached).
4. Wipe down the exterior of the base unit with a damp cloth. Do not allow water to enter the motor or electrical areas.
5. Clean the base reservoir with a soft brush and a vinegar solution (1 part white vinegar to 3 parts water) to remove mineral deposits. Rinse thoroughly.
6. Allow all parts to air dry completely before reassembling.

CAUTION! Never use harsh chemicals, abrasives, or detergents not intended for plastic. Never immerse the base unit, motor, or electrical components in water.

Safety Features

Automatic Shut-off: Unit will stop operating when the water tank is empty or removed. Stable Base Design: Wide footprint to prevent tipping. Cool Mist Technology: Produces room-temperature mist, safe around children and pets.

Regulatory Information

This appliance meets applicable FCC standards. For indoor use only. Copyright © Honeywell International Inc. Honeywell and the Honeywell logo are registered trademarks of Honeywell International Inc. For customer support, replacement parts, or filter orders, visit www.honeywellhumidifiers.com or contact 1-800-332-1110.

Troubleshooting

Reset: Unplug unit for 5 minutes, then restart.

Service: For technical support, call 1-800-332-1110 or visit www.honeywellhumidifiers.com. Do not attempt to repair the unit yourself.