Honeywell Humidifier HUL565 Manual

The Honeywell HUL565 is a cool mist humidifier designed to add moisture to dry air, helping to relieve dryness in the air that can cause irritation to skin, nose, throat, and lips. It features a 1-gallon tank, adjustable humidity control, a wicking filter, an easy-to-fill tank, an auto shut-off function when empty, and a quiet operation ideal for medium-sized rooms. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Water Tank, Base with Motor, Wicking Filter, Humidity Control Dial, Tank Cap, Mist Outlet.

Installation & Setup

Unpack and inspect all parts. Place on a flat, stable, waterproof surface.

1. Remove all packaging materials from the humidifier and filter.
2. Install the wicking filter: Soak it in cool water for 15-20 minutes, then insert it into the filter frame in the base.
3. Fill the tank: Remove the tank cap, fill with cool, clean water (do not use hot water), and replace the cap securely.
4. Place the tank: Invert the filled tank and place it onto the base, ensuring it sits firmly.
5. Plug into a standard 120V AC electrical outlet.

WARNING! Place on a level surface away from heat sources and electronics. Do not overfill the tank.

First-Time Use

After setup, power on the humidifier and adjust settings.

1. Turn the humidity control dial to the desired setting (Low, Medium, High).
2. Adjust the mist outlet to direct the cool mist away from walls and furniture.
3. Allow the unit to run for a few minutes to begin humidifying the room.
4. Monitor the room humidity and adjust the dial as needed for comfort.

CAUTION! Use only clean, cool water. Never add essential oils or other additives to the water tank.

Specifications

• Tank Capacity: 1 Gallon (3.8 Liters).
• Run Time: Up to 24 hours on low setting.
• Room Coverage: Medium rooms up to 300 square feet.
• Mist Output: Adjustable via control dial.
• Filter Type: Replaceable wicking filter (Model HUL565FILTER).
• Power: 120V AC, 60Hz.
• Dimensions: Approximately 13.5" H x 10.5" W x 9.5" D.
• Weight (Empty): 5.5 lbs.
• Noise Level: Quiet operation, less than 35 dB on low.
• Warranty: 1-Year Limited Warranty.

Controls and Operation

Primary control is the Humidity Control Dial on the front of the unit.

Dial Positions: OFF, LOW, MEDIUM, HIGH. Turning the dial clockwise increases mist output.

Mist Outlet: Can be rotated 360 degrees to direct mist flow.

Filter Change Indicator Light: Illuminates when it is time to replace the wicking filter (typically every 1-2 months).

Auto Shut-Off: The unit will automatically power off when the water tank is empty. Refill the tank to resume operation.

Maintenance & Cleaning

Regular cleaning prevents mold and mineral buildup. Clean every 1-2 weeks during use.

1. Unplug the humidifier from the electrical outlet.
2. Remove the water tank and empty any remaining water.
3. Clean the tank with a mixture of mild dish soap and warm water. Use a soft brush for the interior.
4. Rinse the tank thoroughly with clean water to remove all soap residue.
5. Wipe the base exterior with a damp, soft cloth. Do not submerge the base in water.
6. Allow all parts to air dry completely before reassembling and refilling.

Tip: For disinfecting, use a solution of 1 teaspoon of white vinegar per gallon of water. Rinse thoroughly afterward.

Filter Replacement

The wicking filter should be replaced every 1-2 months, or when the Filter Change Indicator light turns on.

1. Unplug the humidifier and remove the water tank.
2. Remove the old filter from the filter frame in the base.
3. Soak the new filter (Model HUL565FILTER) in cool water for 15-20 minutes.
4. Insert the new, soaked filter into the filter frame.
5. Reassemble the tank and base, then plug in the unit.
6. Press and hold the Filter Reset button (if equipped) for 3 seconds to reset the indicator light.

WARNING! Never operate the humidifier without a filter installed. This can cause excessive mineral dust and damage the unit.

Safety Features

Auto Shut-Off: Activates when the water tank is empty to prevent damage to the motor. Tip-Over Protection: The unit is designed to minimize spillage if tipped. Filter Change Indicator: Alerts user when filter replacement is needed for optimal performance and air quality.

Care & Storage

When not in use for an extended period, prepare the humidifier for storage.

1. Unplug the unit and empty all water from the tank and base.
2. Clean all parts thoroughly as described in the Maintenance section and allow to dry completely.
3. Remove and discard the used wicking filter.
4. Store the unit in its original box or a clean, dry place.
5. Do not store with a new filter installed; install a fresh filter at the start of the next season.

CAUTION! Never store the unit with water in the tank, as this can lead to mold and mildew growth.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Copyright © Honeywell International Inc. Honeywell and the Honeywell logo are registered trademarks of Honeywell International Inc. For customer support, replacement parts, or to locate a service center, visit www.honeywellpluggedin.com or call 1-800-332-1110.

Troubleshooting

Reset: Unplug unit for 5 minutes, then plug back in to reset electronic controls.

Service: 1-800-332-1110; www.honeywellpluggedin.com