Honeywell Humidifier QuietCare HCM-6009-TGT Manual

The Honeywell Humidifier QuietCare HCM-6009-TGT is a top-fill cool mist humidifier designed for medium to large rooms up to 600 sq. ft. It features a 1.5-gallon tank, quiet operation, adjustable humidity control, antimicrobial-treated wicking filter, easy top-fill design, and a digital humidistat with auto shut-off. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 1.5-Gallon Water Tank, Digital Humidistat Control Panel, Antimicrobial Wicking Filter, Top-Fill Opening, Mist Outlet, Power Cord, and Carry Handle.

Installation & Setup

Unpack and inspect all contents. Place on a stable, level, waterproof surface away from electronics and furniture.

1. Remove all packaging materials from the humidifier and tank.
2. Install the wicking filter: Remove filter from package, soak in cool water for 15-20 minutes, then insert into filter frame.
3. Fill the tank: Carry tank to sink, remove cap, fill with cool tap water up to the fill line. Replace cap securely.
4. Place tank on base: Align tank with base and set down gently.
5. Plug into a 120V AC outlet.

WARNING! Use only cool, clean tap water. Do not use hot water, additives, or essential oils. Ensure unit is on a flat, stable surface to prevent tipping.

First-Time Use

Power on the humidifier; set your desired humidity level and mist output.

1. Press the POWER button to turn on the unit.
2. Set desired humidity: Use the UP/DOWN buttons to select a humidity level between 30% and 60% RH.
3. Select mist output: Press the SPEED button to cycle through Low, Medium, and High settings.
4. The digital display will show current room humidity and set point.
5. The humidifier will run until the desired humidity is reached, then enter standby mode.

CAUTION! Always place the humidifier at least 12 inches away from walls and furniture. Do not block the mist outlet.

Specifications

• Model: HCM-6009-TGT (QuietCare)
• Tank Capacity: 1.5 gallons (5.7 liters)
• Coverage Area: Up to 600 sq. ft.
• Run Time: Up to 24 hours on Low setting
• Humidity Control: Digital humidistat (30-60% RH)
• Mist Output: Adjustable, 3-speed settings
• Filter Type: Antimicrobial wicking filter (replacement part #HWF090)
• Power Source: 120V AC, 60Hz
• Dimensions (LxWxH): Approx. 15.5" x 10.5" x 17.5"
• Weight (empty): 7.5 lbs

Controls and Operation

Control Panel: POWER Button, HUMIDITY UP/DOWN Buttons, SPEED Button, FILTER Indicator Light, and Digital Display.

Display Icons: Current Humidity, Set Humidity, Speed Setting (1,2,3), Filter Alert, Empty Tank Indicator.

Operation: Set desired humidity level. The humidifier will run until room reaches set point, then auto shut-off. It will restart if humidity drops below set point. Use SPEED to adjust mist output. The FILTER light will illuminate when it's time to replace the wicking filter (typically every 1-3 months).

Maintenance & Cleaning

Regular cleaning prevents mineral buildup and microbial growth. Unplug before any maintenance.

1. Daily: Refill tank with fresh, cool water.
2. Weekly Cleaning: Empty any remaining water. Clean tank with a soft brush and a mixture of 1 teaspoon of white vinegar and 1 gallon of water. Rinse thoroughly.
3. Base Cleaning: Wipe base interior with a damp cloth. Do not submerge base in water.
4. Drying: Allow all parts to air dry completely before reassembly.

Tip: Use distilled or demineralized water in areas with hard water to reduce scale buildup and extend filter life.

Filter Replacement

The antimicrobial wicking filter (HWF090) should be replaced every 1-3 months, or when the FILTER indicator light turns on.

1. Unplug the humidifier and remove the water tank.
2. Remove the old filter from the filter frame.
3. Soak the new filter in cool water for 15-20 minutes.
4. Insert the damp filter into the frame, ensuring it is seated properly.
5. Replace the tank and plug in the unit. Press and hold the FILTER button for 3 seconds to reset the indicator.

WARNING! Never operate the humidifier without a filter. This can cause over-humidification and damage the unit.

Safety Features

Auto Shut-Off: Turns off when desired humidity is reached or when the water tank is empty. Tip-Over Switch: Automatically shuts off power if unit is knocked over. Filter Alert: Reminds user to replace filter for optimal performance and air quality.

Care & Storage

When not in use for extended periods, prepare the humidifier for storage.

1. Unplug the unit and empty all water from the tank and base.
2. Clean all parts thoroughly as per weekly cleaning instructions.
3. Allow all parts to dry completely.
4. Remove and discard the old filter. Do not store with a used filter installed.
5. Reassemble the unit and store in its original box in a cool, dry place.

CAUTION! Never store with water in the tank. Always ensure the unit is completely dry to prevent mold or mildew.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Copyright © Honeywell International Inc. Honeywell and QuietCare are trademarks of Honeywell International Inc. For support, visit www.honeywellhumidifiers.com or contact customer service at 1-800-332-1110.

Troubleshooting

Reset: Unplug unit for 60 seconds, then plug back in.

Service: 1-800-332-1110; www.honeywellhumidifiers.com