Honeywell Humidifier QuietCare HCM-6013 Manual

The Honeywell Humidifier QuietCare HCM-6013 is a cool mist humidifier designed for medium to large rooms up to 2300 sq. ft. It features a 1.5-gallon tank, adjustable humidity control, quiet operation, an easy-to-clean design, a refill indicator light, and an auto shut-off function when the tank is empty. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 1.5-Gallon Water Tank, Humidistat Control Dial, Refill Indicator Light, Easy-Fill Opening, Demineralization Cartridge Slot, Mist Outlet, Power Cord, and Cleaning Brush.

Installation & Setup

Unpack and inspect all contents. Place on a flat, stable, level surface away from walls and electronics.

1. Remove all packaging materials from inside and outside the humidifier.
2. Place the humidifier on a waterproof mat or towel in the desired location.
3. Ensure the mist outlet is not directed at walls, furniture, or electronics.
4. Install the demineralization cartridge (WDC-1) if desired to reduce white dust.
5. Fill the tank with cool, clean tap water. Do not use hot water or additives.
6. Place the tank securely back onto the base, ensuring it is properly seated.

WARNING! Always place on a level, waterproof surface. Do not place on carpets or near heat sources. Use only cool water.

First-Time Use

Before first use, clean all parts that come into contact with water as described in the Cleaning section.

1. Fill the tank with cool tap water and place it on the base.
2. Plug the power cord into a standard 120V AC outlet.
3. Turn the humidistat control dial to the desired humidity level (e.g., 40-50% RH).
4. The Power Indicator Light will turn on. Mist should begin to emit from the outlet.
5. Adjust the 360-degree mist outlet to direct moisture where needed.
6. The Refill Indicator Light will illuminate when the water level is low.

CAUTION! Never operate without water in the tank. Always unplug before cleaning or moving.

Specifications

• Model: HCM-6013 QuietCare Cool Mist Humidifier
• Coverage: Up to 2300 sq. ft. (medium to large rooms)
• Tank Capacity: 1.5 Gallons (5.7 Liters)
• Run Time: Up to 24 hours on a single fill (low setting)
• Output: Up to 1.8 gallons per day
• Humidistat: Adjustable dial control
• Noise Level: Ultra-quiet operation (< 30 dB)
• Power Source: 120V AC, 60Hz
• Dimensions (LxWxH): Approx. 15.5" x 11.5" x 20.5"
• Weight (Empty): Approx. 8.5 lbs
• Included Accessories: Cleaning brush, User manual

Controls and Operation

Primary control is the Humidistat Dial on the front of the unit.

Operation: Turn the dial clockwise to increase humidity output (higher setting) and counter-clockwise to decrease output (lower setting). The unit will run until the desired room humidity is reached or the tank is empty.

Indicator Lights:
Power Light (Green): Illuminates when unit is plugged in and operating.
Refill Light (Red): Illuminates when the water tank is empty or nearly empty.

Auto Shut-Off: The humidifier will automatically turn off when the tank is empty. The red Refill Light will remain on until the tank is refilled.

Maintenance & Cleaning

Regular cleaning is essential to prevent mold and mineral buildup. Clean at least once a week during use, or more often in hard water areas.

1. Unplug the humidifier from the electrical outlet.
2. Remove the water tank and empty any remaining water.
3. Separate the tank from the base. Remove the demineralization cartridge if installed.
4. Clean all interior surfaces of the tank and base with a mild detergent and the provided cleaning brush. Do not submerge the base in water.
5. Rinse thoroughly with clean water to remove all soap residue.
6. Wipe the exterior with a soft, damp cloth. Do not use abrasive cleaners.
7. Allow all parts to air dry completely before reassembling and refilling.

CAUTION! Never use harsh chemicals, bleach, or ammonia. Never immerse the base unit in water.

Filter Information

This model uses a Demineralization Cartridge (WDC-1) to reduce white mineral dust. It is not a bacteria filter.

• Replacement: Replace the cartridge every 30-60 days, or as needed, depending on water hardness.
• Installation: Soak new cartridge in cool water for 15 minutes. Insert into the slot in the base before placing the tank.
• Note: Using the demineralization cartridge is optional but recommended for areas with hard water to minimize white dust on furniture.

Safety Features

Auto Shut-Off: Automatically powers off when the water tank is empty to prevent damage.
Tip-Over Protection: Unit is designed to minimize spillage if tipped.
Cool Mist Technology: Produces a cool, safe mist—no risk of burns from hot water or steam.
Electrical Safety: UL-listed for safety in the USA and Canada.

WARNING! To reduce risk of fire, electric shock, or injury:
- Always unplug before cleaning or servicing.
- Do not operate with a damaged cord or plug.
- Do not block mist outlet or air intakes.
- Use only cool, clean tap water. Do not add essential oils or other chemicals.

Care & Storage

When not in use for an extended period (e.g., summer months), prepare the humidifier for storage.

1. Unplug the unit.
2. Empty and thoroughly clean all parts as described in the Cleaning section.
3. Allow all parts to air dry completely.
4. Reassemble the unit and store in its original box or a clean, dry place.
5. Remove and discard any used demineralization cartridge before storage.

Tip: Never store with water in the tank, as this can lead to mold growth and damage.

Regulatory Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Honeywell and QuietCare are trademarks of Honeywell International Inc., used under license. For support, visit www.honeywellpluggedin.com or contact customer service at 1-800-332-1110.

Troubleshooting

Reset: Unplug unit, wait 10 seconds, and plug back in.

Service: For warranty service or technical support, contact Honeywell Customer Care at 1-800-332-1110 or visit www.honeywellpluggedin.com.